一、拓扑图：
二、IBGP邻居学来的信息，不会传递给另外的IBGP邻居，需要再去手动指定邻居，BGP这条路径能不能通，要看这条路径否成为最佳路径和下一跳是否正确与可达：
1、配置各路由器的IP地址以及配置BGP协议。现在来看一下R3的路由表，看到R3能学到全网的路由：
 
 
3、再去R4上看一下R4的路由表发现没有学到10.1.255.0/30和130.130.1.0/24这两条路由：
 
 
8、但我在R4上traceroute 10.1.255.4之后，发现R4的路由表发生了变化10.1.255.0/30 不存在了。
 

 

R4#traceroute 10.1.255.4

 

Type escape sequence to abort.

Tracing the route to 10.1.255.4

 

  1 10.1.255.9 52 msec 32 msec 16 msec

  2  *  *  *

  3  *  *  *

  4  *  *  *

 

R4#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

       E1 - OSPF external type 1, E2 - OSPF external type 2

       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

       ia - IS-IS inter area, * - candidate default, U - per-user static route

       o - ODR, P - periodic downloaded static route

 

Gateway of last resort is not set

 

     10.0.0.0/30 is subnetted, 3 subnets

B       10.1.255.4 [200/0] via 10.1.255.9, 00:00:24

C       10.1.255.12 is directly connected, Serial1/1

C       10.1.255.8 is directly connected, Serial1/0

     150.150.0.0/24 is subnetted, 1 subnets

B       150.150.1.0 [20/0] via 10.1.255.14, 00:23:42

 

R4#ping 10.1.255.4

 

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.1.255.4, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 4/26/52 ms

R4#

 

         (超过8万字一篇发不了。待续，请接着看下篇)

R4#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

       E1 - OSPF external type 1, E2 - OSPF external type 2

       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

       ia - IS-IS inter area, * - candidate default, U - per-user static route

       o - ODR, P - periodic downloaded static route

 

Gateway of last resort is not set

 

     10.0.0.0/30 is subnetted, 3 subnets

B       10.1.255.4 [200/0] via 10.1.255.9, 00:00:21

C       10.1.255.12 is directly connected, Serial1/1

C       10.1.255.8 is directly connected, Serial1/0

     150.150.0.0/24 is subnetted, 1 subnets

B       150.150.1.0 [20/0] via 10.1.255.14, 00:02:27

 
4 、终其原因是因为：IBGP对等体学习到的路由，是不会向其它的IBGP对等体通告的。拓扑中的R3从IBGP对等体R4学来的路由是不会向R2这个IBGP对等体通告，同理R3从R2学来的路由也不会向R4通告。所以就造成了R2和R4学不到完整的路由信息。
5、先在R2和R4上互指IBGP邻居，一定要互指，不然邻居不能完全建立起来：
 
R2(config)#router bgp 64513

R2(config-router)#nei 10.1.255.10 remote 64513

R4(config)#router bgp 64513

R4(config-router)#nei 10.1.255.5 remote 64513
 
6、相互指定完IBGP邻居之后，用clear ip bgp  *  把路由表涮新一下。然后再来看一下R2和R4的路由表：
 
R2#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

       E1 - OSPF external type 1, E2 - OSPF external type 2

       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

       ia - IS-IS inter area, * - candidate default, U - per-user static route

       o - ODR, P - periodic downloaded static route

 

Gateway of last resort is not set

 

     10.0.0.0/30 is subnetted, 4 subnets

C       10.1.255.4 is directly connected, Serial1/1

C       10.1.255.0 is directly connected, Serial1/0

B       10.1.255.12 [200/0] via 10.1.255.10, 00:00:47

B       10.1.255.8 [200/0] via 10.1.255.6, 00:00:56

     130.130.0.0/24 is subnetted, 1 subnets

B       130.130.1.0 [20/0] via 10.1.255.1, 00:00:45

     150.150.0.0/24 is subnetted, 1 subnets

B       150.150.1.0 [200/0] via 10.1.255.14, 00:00:24

R2#

R4#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

       E1 - OSPF external type 1, E2 - OSPF external type 2

       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

       ia - IS-IS inter area, * - candidate default, U - per-user static route

       o - ODR, P - periodic downloaded static route

 

Gateway of last resort is not set

 

     10.0.0.0/30 is subnetted, 4 subnets

B       10.1.255.4 [200/0] via 10.1.255.5, 00:00:11

B       10.1.255.0 [200/0] via 10.1.255.5, 00:00:11

C       10.1.255.12 is directly connected, Serial1/1

C       10.1.255.8 is directly connected, Serial1/0

     150.150.0.0/24 is subnetted, 1 subnets

B       150.150.1.0 [20/0] via 10.1.255.14, 00:05:26

R4#

 
7 、通过互指邻居，发现R2能学到全网的路由但是R4却不能学到130.130.1.0/24这条路由，而且还发现到10.1.255.4与10.1.255.0 走的都是10.1.255.5。
 
R4#ping 10.1.255.4

 

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.1.255.4, timeout is 2 seconds:

.....    (发现不通)

Success rate is 0 percent (0/5)

R3#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

       E1 - OSPF external type 1, E2 - OSPF external type 2

       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

       ia - IS-IS inter area, * - candidate default, U - per-user static route

       o - ODR, P - periodic downloaded static route

 
Gateway of last resort is not set

 
     10.0.0.0/30 is subnetted, 4 subnets

C       10.1.255.4 is directly connected, Serial1/0

B       10.1.255.0 [200/0] via 10.1.255.5, 00:07:05

B       10.1.255.12 [200/0] via 10.1.255.10, 00:06:59

C       10.1.255.8 is directly connected, Serial1/1

     130.130.0.0/24 is subnetted, 1 subnets

B       130.130.1.0 [200/0] via 10.1.255.1, 00:06:50

     150.150.0.0/24 is subnetted, 1 subnets

B       150.150.1.0 [200/0] via 10.1.255.14, 00:06:29

 
2 、去看一下R2的路由表，发现R2没有学到10.1.255.12/24和150.150.1.0/24这两条路由：
 
R2#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

       E1 - OSPF external type 1, E2 - OSPF external type 2

       i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

       ia - IS-IS inter area, * - candidate default, U - per-user static route

       o - ODR, P - periodic downloaded static route

 

Gateway of last resort is not set

 

     10.0.0.0/30 is subnetted, 3 subnets

C       10.1.255.4 is directly connected, Serial1/1

C       10.1.255.0 is directly connected, Serial1/0

B       10.1.255.8 [200/0] via 10.1.255.6, 00:01:16

     130.130.0.0/24 is subnetted, 1 subnets

B       130.130.1.0 [20/0] via 10.1.255.1, 00:00:46